CNC PROGRAM AND PROGRAMMING OF CNC MACHINE
DOI:
https://doi.org/10.36706/jmse.v7i1.37Keywords:
CNC Program, CNC Machine, Manufacturing SystemAbstract
A programming to make parts are CNC Programming (Computer Numerical Control Programming) for machines. An NC program consists of a sequence of instructions that control the motion and automatic sequences of an NC Machine to perform a particular processing task. In a general sense, the term NC programming refers to the creation of control data for machining workpieces on NC and CNC machines. NC programming has a decisive influence on the cost-effectiveness and profitability of NC manufacturing. The selection of a programming system is mostly guided by the need for software that is suitable for the application at hand, readily available, and as universally applicable as possible.
Downloads
References
S. Krar, “COMPUTER NUMERICAL CONTROL PROGRAMMING BASIC.”
M. Kovacic, M. Brezocnik, I. Pahole, J. Balic, and B. Kecelj, “Evolutionary Programming of CNC Machines,” J. Mater. Process. Technol., vol. 164–165, pp. 1379–1387, 2005, doi: 10.1016/j.jmatprotec.2005.02.047.
Z. Mu, G. Zhang, Y. Ran, S. Zhang, and J. Li, “A Reliability Statistical Evaluation Method of CNC Machine Tools Considering the Mission and Load Profile,” IEEE Access, vol. 7, pp. 115594–115602, 2019, doi: 10.1109/access.2019.2935622.
S. N. Grigoriev, A. A. Kutin, and V. V. Pirogov, “Advanced Method of NC Programming for 5-Axis Machining,” Procedia CIRP, vol. 1, no. 1, pp. 102–107, 2012, doi: 10.1016/j.procir.2012.04.016.
J. Duda and J. Pobozniak, “The Architecture of Intelligent System for CNC Machine Tool Programming,” Procedia Manuf., vol. 11, no. June, pp. 501–508, 2017, doi: 10.1016/j.promfg.2017.07.143.
Y. Koren, “Computer-Based Machine-Tool Control,” no. March, pp. 81–83, 1977.
T. Schroeder and M. Hoffmann, “Flexible Automatic Converting of NC Programs. A Cross-Compiler for Structured Text,” vol. 7543, no. May 2016, doi: 10.1080/00207540500455841.
R. Wdowik, M. Magdziak, R. M. C. Ratnayake, and C. Borsellino, “Application of Process Parameters in Planning and Technological Documentation: CNC Machine Tools and CMMs Programming Perspective,” Procedia CIRP, vol. 78, pp. 43–48, 2018, doi: 10.1016/j.procir.2018.09.054.
R. Licari, E. Lo Valvo, and M. Piacentini, “Part Program Automatic Check for Three Axis CNC Machines,” J. Mater. Process. Technol., vol. 109, no. 3, pp. 290–293, 2001, doi: 10.1016/S0924-0136(00)00812-8.