The Effect of Sinking Parameters To Optimize Response at Edm of Aisi H13 Using Taguchi Fuzzy Method
DOI:
https://doi.org/10.36706/jmse.v4i1.26Keywords:
EDM sinking, cutting depth end (CDE), the rate of wear of the electrode (RWE), the rate of erosion material (REM), the surface roughness (SR), the Taguchi-Fuzzy methodDownloads
References
Lin, C.L., Lin, J.L. & Ko, T.C., 2002. Optimisation of the EDM Process Based on the Orthogonal Array with Fuzzy Logic and Grey Relational Analysis Method. journal of Advance Manufacturing Technology, pp.271–277.
Rochim, T., 2007. Klasifikasi Proses, Gaya dan Daya Pemesinan. Lab.Teknik Produksi dan Metrologi Industri ITB, Penerbit ITB, Bandung. Bandung: Institut Teknologi Bandung.
Soejanto, I., 2009. Desain Eksperimen dengan Metode Taguchi Pertama., Yogyakarta: Graha Ilmu.
Krar, S. F.& Check, A., 1997. Technology of Machine Tools fifth edit., Mc-Graw Hill:International Editions.
Kusumadewi, S. & Purnomo, H., 2010. Aplikasi Logika Fuzzy untuk Pendukung Keputusan kedua ed., Yogyakarta: Graha Ilmu.
Lin, J.L. & Lin, C.L., 2002. The use of the orthogonal array with grey relational analysis to optimize the electrical discharge machining process with multiple performance characteristics. International Journal of Machine Tools & Manufacture, 42, pp.237–244.
Bagiasna, K., 1979. Proses-proses Non Konvensional Diktat Kul., Bandung:Departemen Mesin ITB.Ramesh, S., Karunamoorthy, L. & K. Palanikumar, 2008. Surface Roughness Analysis in Machining of] Guitrau,
E.B., 1997. The EDM Handbook, Cincinnati: Hanser Gardner Publications.
